Quote:
Originally Posted by SnowyCamaro
Avalanche ones
http://www.rockauto.com/catalog/rafr...&parttype=8848
right #15284094
left #15284093
they do not sell the sprayers separate but if the dimensions work out you could probably do a direct swap and just have to run some lines from your current nozzles to the arms. One thing you would have to check is the length of these arms. If i was doing this I would just go to dealer with measuring tape and measure them off a current avalanche or tahoe. Then confirm with the parts guys that they use the same crush washers to hold them in place if not buy a set of those too. Swap em out and run some new lines. Could probably get some lines from home depot and a couple of fittings. Then just get creative and figure out a good route for the lines so they won't get pinched anywhere.
|
Thanks will do.
As far as not having them for me no issue but the wife drives it too so I prefer to have them for her just in case.
Sent from my iPad2 on space mountain