Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - How many New Jersey drivers have put their front license plate bracket on?

faninc · 07-21-2009, 10:02 PM

As mentioned in another forum, mounting plate without drilling holes...for NJ drivers like me.

you will need to drill one new hole below the provided mounting holes (the lower holes) then you thread a long tie 12-14 inches through the hole from the bracket. then thread the tie through the grill and catch with your fingers and then through the new lower holes drilled and "set the bracket as made to sit. Once set, pull ties through lock and pull tight so that the lock part of the tie fits and sits in the recessed bracket hole. This will allow the plate to sit on the bracket flush. Cut the excess tie and mount plate, look mom no holes in the bumber and very secure!

best and good luck!

07-21-2009, 10:02 PM	#9
faninc Drives: 2010 Camaro RS in SIM Join Date: May 2009 Location: NJ Posts: 563 View My Garage	As mentioned in another forum, mounting plate without drilling holes...for NJ drivers like me. you will need to drill one new hole below the provided mounting holes (the lower holes) then you thread a long tie 12-14 inches through the hole from the bracket. then thread the tie through the grill and catch with your fingers and then through the new lower holes drilled and "set the bracket as made to sit. Once set, pull ties through lock and pull tight so that the lock part of the tie fits and sits in the recessed bracket hole. This will allow the plate to sit on the bracket flush. Cut the excess tie and mount plate, look mom no holes in the bumber and very secure! best and good luck!