Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

dan0617 · 07-23-2013, 02:16 PM

Don't laugh but on my vette I had a Mr Freeze kit from Anderson Ford Motorsport. No electrical parts to fail, very consistent. I was running 70% meth through the Vortech T trim at 16 psi boost. My only complaint was the tank size was small for the size of nozzle i was running. 16 psi can take alot of meth if you tune for it! I took the low washer fluid sensor out of the washer reservoir in the bottom of the Mr Freeze tank, was the only safety feature needed! Thought about doing the same thing with this car but I intercool with nitrous and its enrichment fuel!

For sure not the best meth kit but it is the cheapest and quickest to install and likely the most fail safe!

07-23-2013, 02:16 PM	#12
dan0617 Drives: 2011 Inferno Orange SS Convertible Join Date: Apr 2012 Location: Tyrone, PA Posts: 640 View My Garage	Don't laugh but on my vette I had a Mr Freeze kit from Anderson Ford Motorsport. No electrical parts to fail, very consistent. I was running 70% meth through the Vortech T trim at 16 psi boost. My only complaint was the tank size was small for the size of nozzle i was running. 16 psi can take alot of meth if you tune for it! I took the low washer fluid sensor out of the washer reservoir in the bottom of the Mr Freeze tank, was the only safety feature needed! Thought about doing the same thing with this car but I intercool with nitrous and its enrichment fuel! For sure not the best meth kit but it is the cheapest and quickest to install and likely the most fail safe! __________________ 2011 SS IOM Vert. ECS Vortech 13+ psi, Water/Meth, ID850’s, ZL1 pump with MSD Voltage Booster, 2800 stall, LT headers, Drag radials, Drag alignment, Cradle Bushings. A million other supporting mods. Tuned by Ted.