Thread
:
How To Install Catch Can on a ZL1
View Single Post
07-12-2013, 03:51 PM
#
156
Normagene
Drives: 2013 Ashen Gray M6 ZL1
Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
View My Garage
The install is done! So here's how it all went. Got the wrong bracket, but it didn't matter because I didn't install to the radiator shroud. Instead I used the threaded hole (there are two, I used the one furthest to the left) in the crossbeam below the radiator. Placed the can in the highest bracket position so I have plenty of room underneath to open/close the drain. Also it didn't come with enough hose so I needed an additional two feet of 3/8th and I also had to get a one foot piece of 1/2 inch hose since the Roto Fab "T" is 1/2 inch. Plus a hose connector reducer 1/2 to 3/8th which was another six bucks from JEGs. So like an additional $12 to do the install
Once I had everything I needed, it went in super easy. Probably like 15 minutes. Here's a few pictures, I wanted everything to show as little as possible. Oh, I still need two Black Zip Ties. Had to use white ones, that's all I had on hand, but will replace those ASAP.
Normagene
View Public Profile
Find More Posts by Normagene