[SSdude]

Hi Guys,

I'm in the process of redoing my front end. I went in for an Aggressor 2 bumper from rideskinz which is a polyurethrane based bumper. The lower grill port on the aggressor is much bigger than the OEM version because of which it has lesser structural rigidity so a brace is required to prevent the front tip from flexing downward at higher speeds. I have 2 options

1. Bolt a steel brace to either the frame or the reinforcement bar and make the lower lip rest on the brace inside and leave the front end clean.
OR
2. Put in splitter support rods that are bolted on small steel braces tucked behind/under the bumper.

What do you think works better?

Here's a pic in which I photoshopped some splitter support rods over the current bumper to give you some perspective.Let me know what you guys think.