Quote:
Originally Posted by oldschoolkat
@Snoman...did u cut dynomat into squares or did it come on a sheet?..Good job on the install
Sent from my SM-N920P using Tapatalk
|
Thank you!
A single case contains 9 sheets; 18" x 32" and I used nearly 3 cases (27 sheets / 105 sq ft)
I highly recommend cutting each sheet into 6x pieces of 18" x 5.33" and then in half again. You can take the time to cut each piece perfectly, but at the end of the day; When you're using 3 cases for a complete install, it's a complete waste of time.
Don't even measure it, just slice the entire sheet in half down the center horizontally, leaving you with 2x pieces ~9" x 32"
> Cut those 2 pieces in half, leaving you with 4 pieces ~9" x 16"
> Cut those 3 pieces into thirds, leaving you with 12 pieces ~9" x 5.33"
Remove all seats, panels, front and rear seatbelts and center console, from there;
- Do the trunk first
- Come down the back seating area
- Line the front floor as much as able while lifting the carpet up (PITA)
- Cover the back deck top/bottom
- Line both rear wheel wells as much as you can reach
- Save 4 sheets (48 pieces) for the doors
- Take very special care in not covering any obvious holes in the car where the panels "lock into"
- You'll need three cases of dynolyner for doors, front and rear seating areas, use whatever is remaining in trunk
- Don't cut yourself