Question on lowering the diff to replace bushings
I'm dropping the rear end housing to replace the Diff bushings and have a question on drive shaft removal. I've got the three 18mm bolts off and there is a pilot shaft inside the drive shaft. The directions say to use a pry bar and move the drive shaft forward and lower it. I've pryed on it a bit and it seems to bottom out just as it's about to come off the pilot shaft. I don't want to pry too hard and break something? Do I just put a little more into the pry bar and get it off the pilot shaft?
Thanks
__________________
LSA supercharger, Borla S-Type cat back, BMR/ Pedders Suspension, Kooks stepped LT's, GM 3.91, and RDP tune.
|