I think I am posting in the right place for this:
I recently installed a Revolutions Reverse Hood Kit, The factory latch is removed altogether.
Because of this the circut for the Alarm/ Remote start is not working because it is obviously disconnected.
Heres where it gets confusing: 3 wires on the latch (Black-Pink-Yellow),
only 2 wires on the Harness (Black-Pink).
The latch in the "Hood open position" shows a directional (Diode) signal thru my meter on the black and pink. (start disable and hood open signal)
In the "Hood Closed Position" it shows the same signal on the Black and Yellow of the latch connector (remote start works).
I unplug the connector and the remote start stops working?? Does the vehicle connector (as opposed to the latch connector) have a resistor in it to show a loop for the start circut?? Or does it provide a "Directional" or "Reverse" signal. As I said there is no yellow wire at the vehicle side of the connector?
Can I install a diode across the black and yellow (even though there is no wire in it) on the vehicle connector to false it into thinking it has a hood latch?
I would really like to have my remote start working again!