View Single Post
Old 05-11-2011, 06:04 PM   #132
SummoneR
Paul
 
SummoneR's Avatar
 
Drives: '10 2SS/RS M6 "Marauder"
Join Date: Mar 2009
Location: NOR*CAL
Posts: 6,257
Send a message via Yahoo to SummoneR
Quote:
Originally Posted by curlee83 View Post
I have added new trim panels for the doors and wired the led lights. How do I get the light pipe/tubing? I did not think about this before installing. Can someone please help me out? I will also need the splitter for the dash install. Thank you.
Send 2SSRS a PM that you want to buy a splitter and light tube.

As seen in the OP.
Quote:
Originally Posted by Gene Culley View Post
Hello All,

I know 2SSRS and some others have done an awesome job explaining how they have done the ABL mod. In reading some of their DIY threads I was still left with some questions, so I am just doing a simple write-up in my own manner to see if I can help out at all. I read and posted in 2SSRS’s original thread here…http://www.camaro5.com/forums/showthread.php?t=40804.

2SSRS (Ofer is his real name) has a great post and helped me out tremendously during the process. Again, my write-up is simply to write up my experience and to answer some of the questions I had during my project.

The last 8 of my VIN are A9113647 and it is a 2010 Camaro 2SS/RS. Ofer states that GM pre-wired all of the 2010 Camaro’s up to VIN A9160000 for the ABL mod. After these VIN’s you will have to use a t-tap method for power, which is basically using a connector to tap power from another wire. You can get the t-tap method from Ofer’s thread…http://www.camaro5.com/forums/showthread.php?t=40804.

The method I used requires no drilling at all.
__________________
SummoneR is offline   Reply With Quote