View Single Post
Old 10-12-2013, 11:31 AM   #18
UNRIVALED SS
 
UNRIVALED SS's Avatar
 
Drives: 2010 Camaro SS
Join Date: Aug 2010
Location: TN
Posts: 571
Send a message via Yahoo to UNRIVALED SS
Try this

Quote:
Originally Posted by hiddenangels89 View Post
Hope this thread isn't too dead by now...

I'm at 486rwhp and 467rwtq on a Mustang Dyno, my current set up is:

L99
Edelbrock SC w/ 3.5" pulley (upgraded from the 3.875") (w/ the 52 lb injectors)
Borla LT Headers
Cat Delete, resonator delete, straight pipe to flowmaster mufflers
AEM Cold Air Intake
Tune

I want to break the 500rwhp mark, hopefully it can take some easy mods to get there?

will the 3.25" pulley be too much PSI for my set up? unless anyone else can tell me some easy & not so expensive mods to go with to get me to the 500rwhp range?

My overall goal was originally 550rwhp, but i'm trying to avoid having to put a cam in and i don't want forged internals... but if that's the way, then that's the way, so i've dropped it to 500rwhp.

-May
Try a ported throttle body and then retune . It should get you close to your goal. It will actually make the car feel more powerful with the better response also
UNRIVALED SS is offline   Reply With Quote