View Single Post
Old 01-20-2010, 01:22 PM   #12
Proroc
 
Proroc's Avatar
 
Drives: 2013 Red ZL1 Coupe
Join Date: Sep 2009
Location: Salem, Va.
Posts: 159
I used fishing line to cut the rear bowtie and SS emblem off with. I heated them with a heat gun and use the fishing line to cut the glue off the backing. If you are carful you can get it loose enough to pull it off. The bowtie has two post for alinement but it is not bolted.

The front ss emblem has tabs. If you reach around it you can fell where you push in on the tabs and pull on the emblem. It will pop out once you get it loose so be carful. I though I scratched the bumper when I ripped it out once the tabs popped loose. You can run a plastic knife up each side to get the tabs loose. I used a small flat blade screwdriver but I was carful not to scratch the sides of the grill.

Hope this helps.
__________________
New 2013 ZL1 Red Coupe with the Roto Fab CIA and the rest is stock ...so far

3000 miles now..7.97 1/8 mile on Drs, Autocross, and 2.14 full course at VIR.

SOLD!!! 2010 BLACK ON BLACK 2SS LS3, WHTIE STRIPES, Permachrome factory rims widen 10.75 rear 305/35 nittos, 275s p-zeros on the front, LIVERNOIS TUNED MAGIE-550RWHP, ROTO FAB, EBACH PROKIT, SLP emblems
Proroc is offline   Reply With Quote