View Single Post
Old 06-18-2013, 06:49 PM   #7
Moreno1
 
Drives: G5.R
Join Date: Sep 2010
Location: SoCal
Posts: 2,377
[QUOTE=krusher;6683039]After personal messages and tearing into it I realized just how simple it was and I was asked by Nate to create a DIY. So here is my best shot.[/QUOTE]

Awesome write up Krusher! As you stated, this is a very easy mod to perform that makes a huge difference. The biggest hurdle is just getting out there and doing it.

My recommendation for most would be just to remove the wire loom to get familiar with how the wires are routed. You'll see there's not much to it and it will become less intimidating.

This is also one of the cheapest mods you can do to clean up the engine bay.
Moreno1 is offline   Reply With Quote