Day 1:
So far so good (I hope!
) So today, I set up my work station in my garage, nothing special
Now for what I have done so far. I decided to start out with small and flat parts, so I went with the center A/C Vent and the drivers side dash trim. I know it isn't a lot, but I thought it would be good practice.
first, I sanded them with 100 grit sand paper.
Next, I sprayed them with black spray paint. I did a couple of thin coats, nothing too much, but this was just so that if the carbon fiber was to separate, you wouldn't see the silver.
Now that the parts are prepped, I then cut out the carbon fiber to the appropriate size.
I am gonna start the wrapping in the morning, so this is all I have for today. But more will come tomorrow