NON RS CAR HALO INSTALLATION
This is the first part of the project where we separate the two pieces of the headlight assembly to install the LED halos. I reccomend using an oven that isnt used for cooking for people although many people say it isnt enough heat to cause any harm id rather not find out. We were lucky enough to have a member of the club who happen to use an oven for powder coating and other automotive jobs. It took some doing and some patience but with using the oven it wasnt too hard a job. The idea is to heat up the glue enough so the two pieces can be pryed apart. We found the best results at 275 for a half hour.
(very special thanks to Kendell, Pete Caliendo for the assemblys Carole and Bruce Miller for the oven and all the help) you guys are what it is all about
TOTAL TIME: 1.5 hours including bake time
TOOLS NEEDED:
oven
heat gun
flat head screwdriver
ice pick
nylon pry bars
utility knife
work gloves
PARTS LIST:" A SKUNK POSSESSED "
1. HID BI XENON HEADLIGHTS EBAY $52
2. HEADLIGHT TINT 6% SMOKED FROM BIG WORM GRAPHICS $29
3. ADVANCED AUTOMOTIVE CREATIONS RED HALOS $189
4. LED SUPER BRIGHT LIGHTING 19 INCH RED STRIPS (5) $52
5. UNPAINTED HERITAGE GRILL FESLERBUILT.COM $230 FREE SHIPPING
6. RADIO SHACK ILLUMINATED SWITCHES
use gloves the assemblys gets hot
its a bit of work to get at all the glue
GM did a great job putting this together