Thread: Hurst Shifter Fix
View Single Post
Old 03-26-2013, 07:26 AM   #284
RogerBzSS
 
RogerBzSS's Avatar
 
Drives: 11 IBM n White 2SS/RS M6
Join Date: May 2011
Location: Tewksbury Ma
Posts: 358
Quote:
Originally Posted by AMCBimmer View Post
No nylon bushings in there.
I would measure the shifter and the bushing ends and from that you can
determine the difference in size??

I would think it's possible hurst changed the bushing hole size??
__________________
Black CIA -Powder Coated Red Air Scoop - Vmax Ported Throttle Body - Ceramic Coated Dynatek Headers - High Flow Cats out thru factory Cat Back - JRE rough idle cam package - Trunion Upgrade - Valve Springs - Hardened Push rods - 3 bolt timing gear - SLP Under drive pully- Washer bottle relo kit - Hurst Short Throw Shifter with updated pin bushing from C5 member NH-SS - IdealG's improved Master Cylinder - GTO Clutch reservoir - L99 Brake Reservoir - Stainless Braided clutch line - wrapped up with a JRE Tune My SS layed down 462 hp on JRE's Superflow Dyno
RogerBzSS is offline   Reply With Quote