finished installing some gm carbonfiber ls3 corvette fuel rail covers today, if anyone is cosidering doing this its kind of a pain in the ass, but not too bad. as stated it requires modification to a flexible fuel line, reroute of the heater hoses
http://www.camaro5.com/forums/showthread.php?t=49050
by the way don't mistake the large quick connecs near the thermostat housing for check valves, there is no real need to reuse them.
you'll laso need to remove the mounts at the rear of the intake for the factory engine cover (10mm bolt and a clip to the fuel rail) and a reroute for the evap line next to the fuel line.
also when you're looking for the coil covers, dont forget the 4 corvette support studs that thread into the valve covers (camaro only comes with 1 and it is shorter than the vette ones) happy butchering
oh, will post pics when i get my camera back from my wife