|
Ok, measure in (toward the center of the steering column) from the chrome ring flange (where you insert the key) 1-7/8 inch. That is where the release tab is. If you have the ignition switch in the OFF position the release tab lines up with the small hashmark cast into the chrome ring flange. The tab is only about 3/8" wide and needs to be pushed in about 1/8" to release. I have had times where the aluminum casting flash covered over the tab but if you follow the measurements it is there.
Sorry I don't have any pics but it's been a looooong time since I've done this. I did find an ignition switch in my basement to measure though!
|