[Rogan]

Remind me never to tackle a job like this late at night. I tried to avoid the heat that way, but I forgot rest is equally if not more important than trying to cool.


Problem one is that I can't snake the stock sway bar out. I dont have a saw and I'm determined to get it out without having to get a saw. Can I get a torch and burn the clamps? If those were off it would be cake to snake out. I tried to be patient...like an hour patient but no luck. Was worried about screwing up the hoses below.


Ok below are some pics. Problem two is... The spring top bolt is protruding through too high. I read that OE rubber will protrude about 1/4" but the bolt is the problem.