|
Sure would be nice to cut the duct. but then you would have to come up with a good repair. Hey ofer, since your further into this then anybody right now. if you cut the duct clean off at the right side of the IP cluster opening. And remove the one screw on the left side of the duct. Can you pull that piece out from under the dash. It looks like you can. then for a repair going back in........ line the inside of the removed cut duct with a protruding piece of the same plactic and maybe some foam to seal. And slid it into the other cut end.
To fasten plactic pieces on the inside of the cut you could use maybe rivets or epoxy specially made for plactic. just an idea, this might be a better way to go for the level of comfort for most on this post. I wish I could start on mine and be of more help.
|