View Single Post
Old 01-19-2011, 08:22 AM   #14

BlownSS's Avatar
Drives: 2010 Camaro SS/RS
Join Date: Oct 2009
Location: Lincoln Nebraska
Posts: 1,758
Originally Posted by Duke View Post
Have you tried bending the 2 prongs on each muffler that goes into the hangars?
Not yet.....maybe soon!

Originally Posted by jrpxxii View Post
Got it. I would at least take it by a shop and have them look at it and see if they can figure out and just let them know if they dont fit without modification, not to install them and then let GHL know as all systems should fit with ease.
this was their reply yesterday.....Argh!

"One of the hangers might have moved from the heat when taken out of the jigs to soon. The slip fit way most companies use is so you can adjust either side to match. Hope this helps.

Jeff "
2010 IOM SS/RS LS3, Hennessey HPE550 Polished Magnuson TVS2300 Supercharger. 3.4 Pulley. Kooks long tube headers / high flow cats. GHL Full exhaust. ZL1 Fuel Pump/ADM FPCM. MSW Bap. JRE ZL1 Race cam with new springs/pushrods/Trunion Upgrade. FIC 850cc injectors. ZR1 Map sensor. CAI Induction. JRE Tune.
BlownSS is offline   Reply With Quote