Thread: spohn or BMR
View Single Post
Old 02-09-2010, 04:21 PM   #22
g-townmach's Avatar
Drives: 2010 2SS/RS
Join Date: Nov 2009
Location: cen-tex
Posts: 873
Originally Posted by axis View Post
How low is your current tunnel brace? It looks like it's more than enough if you replace the current square bar with a flat piece, welded level with the bottom of the side brace. Maybe two seperate pieces spaced apart or put the waterjet to work for a cool design on a full sheet to save on weight. That would provide the needed clearance and still be more than rigid enough for the intended purpose of the brace.
You should check out the G1 tunnel brace. It's made to clear 3 inch exhausts.
g-townmach is offline   Reply With Quote