View Single Post
Old 09-27-2010, 07:21 PM   #260
GearHeadPeter
US Navy Vet
 
GearHeadPeter's Avatar
 
Drives: 2011 2LT/RS, 65 Mustang GT Fastback
Join Date: Oct 2009
Location: Gilbert, AZ
Posts: 1,567
When I did my footweel lighting I too tapped in the gray wire above the gas pedal, but then I ran an extra wire to the passenger side underneath the center console by the gas pedal behind the carpet. I found on the Passenger side a small part of the underdash that had a hole that I could use to thread a screw through and use a double nut to secure it. I put my LED light that was in its holder onto the threaded screw and that served as it ground. The power line was what I ran. I have attached a few pics to give you an idea of how I did mine.

I am working on installing rear courtsey lights in the rear side panels that are a throwback to the types of lights used in the 60's.
Attached Images
     
__________________
2011 - 2LT/RS - RY, A6, Gray Interior - Team LLT:
3rd Camaro on this forum to have a Mylink installed. Installation by GEN5DIY, Heritage Grill, Lloyds Premium Ebony Camaro RS floor mats, Empire Billet Camaro Black sill plates, AAC: LED footwell & interior lighting, Rear Courtesy Lights, LED side markers/turn signals, Plasma P13W DRl bulbs, Formula 1 Pinnacle Series tint, Roto-Fab Yellow CAI & Fuse cover, Technostalgia Afterburner LED taillights, EmblemPros custom V6 hydrocoated carbon fiber/RY engine cover, Pfadt Sport sway bars, Ofer's Backup Camera, and full Brembo brake conversion.
GearHeadPeter is offline   Reply With Quote