wastegating centrifugal
I'm thinking I'm going to try this out. I know the tune will have to be checked for low end timing maps...but that's a short drive and a phone call.
So...I know Padre has done it...who else? I'm needing some gate size suggestions. I was pondering a Tial MVR44. I figure pulley the car down to 12-13 psi (3.12 pulley) but use a boost controller to limit it to about 10.5/11.
I like the stainless parts in the Tial and the v-band connections for sealing.
Anyother size or brand ideas that have been used on an intake tract? (I plan to dig on Yellowbullet too...seen traffic there on this)
__________________
-John S.
Last edited by grocerygetter; 09-09-2013 at 12:17 PM.
|