Quote:
Originally Posted by 2010 Autobot Bumblebee
yes I could reproduce for you..........what color?....black?.......didn't cut out the light but could be done......
|
Not sure if this helps, but here is a picture of the trace of the port for a V6 bumper, with some measurements. Have included 2 pictures that show the angles of the cutout. The bottom angle is 79 degrees, and the top angle is 84 degrees. Where the metal ruler is, the cutout tapers approx 1/16 of an inch on each end. The bottom edge curves out a max of 1/4 inch. (right where the yardstick has 1/4 marked below the 9) The top edge is straight along the yardstick, except where it sticks out on the left end of the cutout. Cut one out of paper and see how it fits on the car, make adjustments to the paper. Than cut them out of vinyl. Hope this helps!
Joe