View Single Post
Old 10-31-2011, 12:01 PM   #23
BMR guy
 
BMR guy's Avatar
 
Drives: 2010 1SS
Join Date: Jan 2010
Location: Tampa, FL
Posts: 1,002
Quote:
Originally Posted by DietCoke View Post
Since I was harassed to type it out in the other forum , here you go. Additional numbers courtesy of BMR



-6 Airbags (Side Curtain, Seats, dash) (-13.4 pounds)
Dash removed, lightened, tubular steel loop cut off of cross brace, cross brace lightened, sound deadening removed from backside of FW (-30 lbs)
Removed rear seats, belts and brackets, and sheet metal holding bracket mounts (-45.4 pounds)
Weld RT-S & tires vs stock 20s (-85 pounds)
Headers/X/Dumps at axle for weight (-60 pounds)
Tubular front crash support (-12 pounds)
Remove rear crash support (-26 pounds)
!Evap (9.7 pounds, not including evap line, which I left in)
!A/C (-49 pounds)
!Wiper Motor Assy (-9 pounds)
!Junk Block Oil Cooler/Heater, unnecessary (-7 pounds)
Lightweight Billet clutch vs. stock (-12 pounds)
Sound deadening removed from under seats, backseats, trunk, including hood/trunk liner (-8 pounds)
Braille battery (-29 pounds)
Windshield Washer Tank + Pump and lines empty weight (4 pounds)


ITEM
WEIGHT (LBS.)
LOWER REAR SEAT
10.2
UPPER REAR SEAT
28
DRIVERS SEAT
54.6
PASSENGER SEAT
44
A/C EVAPORATOR CORE ASSY.
13.4
A/C COMPRESSOR
13.2
A/C CONDENSER
6.4
A/C-HEAT BLOWER MOTOR ASSY
4.2
A/C LINES AND DUCTING
7.6
A/C FIREWALL COVER
3.6
DRIVERS AIR BAG
1.6
PASSENGER AIR BAG
5.4
SIDE AIR BAG (EACH)
3.2
FIREWALL INSULATION
2.8
FLOOR INSULATION
12
TRUNK CARPET AND WELL COVER
15.2
TRUNK COMPRESSOR
6
TRUNK-LID STRUTS (PAIR)
1
FRONT BUMPER
14.6
REAR BUMPER
26.4
RADIO
4
DOOR SPEAKERS (PAIR)
3.6
FLOOR MATS (FRONT PAIR)
4.8
CENTER CONSOLE
8.2
EMERGENCY BRAKE LEVER W/CABLES
6.2
FRONT SEAT BELTS (PAIR)
6
REAR SEAT BELTS (PAIR)
3.6
FRONT BRAKE ROTORS (EACH)
25.4
REAR BRAKE ROTORS (EACH)
24
FRONT CALIPERS (EACH)
11.4
REAR CALIPERS (EACH)
7.4
HOOD
25.3
HOOD INSULATION
1.2
HORNS (PAIR)
1.4
WIPER ASSEMBLY W/MOTOR
8.6
WINDSHIELD COWL PLASTIC
3.6
DRIVESHAFT – 6 SPEED MANUAL
24
FUEL TANK SHIELD
2.8
DRIVE SHAFT HEAT SHIELD
.8
STOCK AIR BOX
7
ENGINE COVER
4.4
CLUTCH ASSEMBLY (INCLUDING FLYWHEEL)
57
How fun was that removing the dash and evaporator? Did you cut the (2) firewall bolts or pull the windshield? It's pretty ridiculous that the first step in the service manual for replacing an evaporater core is to remove the windshield!
BMR guy is offline   Reply With Quote