Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

2SSRS@Gen5diy · 12-10-2009, 12:37 PM

I think its the design of the front end, what is needed as a 3 pivot plate, 1 side is for the side to side movement and the top has to stop it from dropping when you hit a bump, Last it has to pivot the strut.

One thing you can do but GM dos not think it is smart, Is to flip the top big washer the one in side the Engine department,It looks like this.

I tried it and had no problem but was told that it limits the side travel of the strut, We are working on some thing now hope to get back to you soon.

12-10-2009, 12:37 PM	#35
2SSRS@Gen5diy Drives: 2014 Z/28 #82+#192, 18ZLE 66Nova Join Date: Oct 2008 Location: By the lake in AZ Posts: 15,719 View My Garage	I think its the design of the front end, what is needed as a 3 pivot plate, 1 side is for the side to side movement and the top has to stop it from dropping when you hit a bump, Last it has to pivot the strut. One thing you can do but GM dos not think it is smart, Is to flip the top big washer the one in side the Engine department,It looks like this. I tried it and had no problem but was told that it limits the side travel of the strut, We are working on some thing now hope to get back to you soon.