View Single Post
Old 12-14-2012, 05:12 PM   #141
ACS Composite
 
ACS Composite's Avatar
 
Drives: 2010 Camaro
Join Date: Dec 2009
Location: Montreal, Canada
Posts: 1,254
Insert is bolted on using M6 fasteners.... The adhesive between the insert and hood is used to eliminate any potential vibrations or "canning" effect.

No measuring tape is really required, template is your guide, and the trim tolerance is very forgiving since the cut is not visible.

Quote:
Originally Posted by OKCwhiteKnight View Post
Great,thanks.Good to see template is aligned using cowl line and front of hood.The less measuring the better. Similar to my fender vents.I assume the rest is test fit,apply adhesive,put in place and attach nuts.Of course,AFTER painting..lol. I also assume one can cut hood liner to fit and replace?
ACS Composite is offline