Quote:
Originally Posted by bannonm
What brand of sway bar is that? Looks like BMR. The OEM clamps have one round hole and one slightly elongated hole. Looks likes there's too much play in those clamps. Did you do the install? I would loosen them up and reseat the clamps and probably put bigger washers on each side and torque it back up to spec.
If you don't do your own work, I use Supercar Performance right in Minooka to do some of my stuff. The owner Scott is a great guy and does all the work, and his labor rates are low. Coincidentally I used him to put my front sway on because I couldn't get the engine up high enough to slide out the old bar. I'm picking my car up this morning after he did a complete flush of my brake system with Motul 600. Getting ready for this weekend at BlackHawk.
|
Thanks for the tip. He fixed me up this morning. One of the washers was almost completely worn through.