well in theory there is a few ways to go about this.
1. The light that blinks to show the alarm is on in the center of the dash most likely does have constant power to it. I am sure the light unit just pulses power on it own. We can tap into the power before it hits the light assembly.
2. The alarm is off and there is no power to it till its turned on so we must find where the power line is where the alarm is hooked up. tap that and it should give power.
I am going to set the alarm and test some wires or fuses that have power with the alarm on and that dont with alarm off and see what I come up with.
|