Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

pyr0b0y · 08-03-2011, 04:35 PM

Went to the drag strip this past weekend with a couple other camaros. Best of the night was a 12.559 w/ 2.206 60' and a .125 RT. Not very impressive for a S/C camaro but i rolled into it rather than launched the car off the line. Felt a lot better not breaking an axel. It was 90* and didnt have wheel hop. My last run I had HORRIBLE wheel hop and fishtailed all the way into 3rd. I def want to go to the dragstrip again and learn how to lauch. Only improvement from a 12.559!

Last word on the new build: Engine shipped out last week and should be arriving at the shop sometime this week. Turbo kit should be shipping out this week. I'll be going with an Exedy clutch, not sure of the specs but Luke said it'll withstand the power I want!

Fnially decided on a finish for the rims. I need to take pics of my car and will get them done in photoshop if i have time. I will be going with a brushed finish with a chrome lip. The front rims will have a slight concave with a deep concave in the back. Similiar to this design:

08-03-2011, 04:35 PM	#313
pyr0b0y need....more....hp Drives: The Neighbor Hater Join Date: Dec 2010 Location: San Mateo, CA Posts: 4,091	Went to the drag strip this past weekend with a couple other camaros. Best of the night was a 12.559 w/ 2.206 60' and a .125 RT. Not very impressive for a S/C camaro but i rolled into it rather than launched the car off the line. Felt a lot better not breaking an axel. It was 90* and didnt have wheel hop. My last run I had HORRIBLE wheel hop and fishtailed all the way into 3rd. I def want to go to the dragstrip again and learn how to lauch. Only improvement from a 12.559! Last word on the new build: Engine shipped out last week and should be arriving at the shop sometime this week. Turbo kit should be shipping out this week. I'll be going with an Exedy clutch, not sure of the specs but Luke said it'll withstand the power I want! Fnially decided on a finish for the rims. I need to take pics of my car and will get them done in photoshop if i have time. I will be going with a brushed finish with a chrome lip. The front rims will have a slight concave with a deep concave in the back. Similiar to this design: Attached Images __________________ BUILD THREAD BUILT AND MAINTAINED BY BLU808 Mast Motorsports Built LS3 Stroker 418, IPS GT35R Twin Turbos, Exedy GTO4XD Twin Disc Clutch, Aeromotive A1000 Eliminator Stealth Fuel Pump, AEM Meth Injection, DSS 1400hp Axels, BC Coilovers, Pfadt & BMR Suspension, Hawk HPS Pads, Drilled/Slotted Rotors, Hurst Shifter, Custom Roll Cage by Blu808, T3 Ports, 22" Custom Concave Mesh Rims