Quote:
Originally Posted by pyr0b0y
Where did you order the race ramps from?
|
Directly from Race Ramps
Quote:
Originally Posted by 572HP
I love my race ramps (just for getting my low front end into my trailer). This kit would be very nice.
|
Joe, my thoughts exactly! G5.R is going to be pretty lower with 19" and a drop. So I didn't want to be jacking the car and potentially jacking up the bottom. I put my brothers car on it and it gives you tremendous clearance.
Quote:
Originally Posted by vroomapunk
those ramps are so bad ass!
|
Quote:
Originally Posted by Mr. Unassailable
Looking good.
- Clayton. Official C5Fail4 hater.
|
Quote:
Originally Posted by kjkjr27
+1 Those are awesome!
|
Quote:
Originally Posted by 1977and2010
Those are nice but dam you'd need a seperate trailer just for the ramps.
|
Thanks guys!
Quick update:
Motor mounts
I will say these mounts are very artsy for a factory piece. So I figured they could use some
Before.........
This shows all the insignia that was removed.
You can see seems in this picture that were removed.
After......... much cleaner
This one shows a lot of rough casting and grinding marks.... go figure
Finally some color, powder coated in anthracite.
In this second picture, you can see I replace the nut on the picture above with a ARP chrome molly 12 point. I'm using ARP for the entire project other than the sizes they don’t make. I added the cost off all the ARP bolts and was floored, Close to $3,000 in bolts
More updates tomorrow.