I just installed the bow ties noted by the OP. They were a christmas present from my daughter.
I used a 3/16" drill bit to drill a couple of holes into the OEM gold bow tie. I only let the drill bit get to the back side of the gold bow tie.
I used a flat blade screw driver to pry/break off the gold bow ties.
I used some "Goo Gone" glue remover to remove any remaining glue.
I installed the new bow ties without any problem.
I also received some OEM "SS" (white because I have a 1SS) emblems that I installed just under the "CAMARO" lettering on the front fenders.
|