[JDP Sales]

Originally Posted by specialfx

I'm a bit confused on these subframe mounts, I have this bushing insert kit that I got from another member here(thanks HYPURONE) but they don't seem to fit for my '13 1LE rear end. Chevy seems to have gone to more solid mounts. Is there even an upgrade for these? The big upper ones seem to have little to no flex when I pry on them, but the lowers do seem to move around a little.

You can also trim the "fingers" to make those ones fit, but I'd still recommend a full replacement bushing over the inserts. Getting rid of the soft factory rubber is really a big part of the upgrade.

If cost is a concern, check out the Prothane replacement bushings Part # 7-142. They are a full bushing at about the same cost as inserts.

Best regards,

Tyler
888-308-6007