View Single Post
Old 01-08-2014, 10:33 PM   #3
blake-b


 
blake-b's Avatar
 
Drives: 2009 ZR1
Join Date: May 2010
Location: KCMO
Posts: 3,205
Just pull the old injectors out being careful. Clean up the holes if necessary.Push the new injectors in being careful. If the new ones don't want to go in, you can use some lubricant such as a tiny amount of oil on the orings to help. You will know when they are in place. Then tighten down the bolts, nuts etc for the rails and reattach fuel lines.

Some people will place the injectors in the rails first and then install them into the intake. Just go slow and be careful.

For the pump, you have to drop exhaust and driveshaft, and lower cradle or remove cradle, undo tank straps to access the fuel pump area. OR you can remove your back seat, and being EXTREMELY careful, cut an opening to reach the old pump. There is a thread on here somewhere that has measurements and tips to do that.

You can do either on jackstands. My Squash setup was done in my garage on jackstands.

LPE's instructions to install their pump. Same basic steps will be followed for any installation of a pump.

LPE instructions

Easiest way is to cut the hole but I understand why many people won't do that.
blake-b is offline   Reply With Quote