Quote:
Originally Posted by zkdreads
what did you use to seal back up the lens to the housing. black=ground, yellow=positive
|
I used the stock socket. Just put it back in the housing. Removed the metal tabs off the stock bulb and wedged the bulb back into the socket with the led wires. Another words used the bulb to hold the wires against the contact points. I will eventually get a blank 192 socket and plug the wires into that socket.
Quote:
Originally Posted by showstopper
Looks good can't wait to see the finished product.
|
Thanks!
Quote:
Originally Posted by sene
If its the led strips are flexible couldn't you feed them through the hole in the back and not worry about splitting the lamp open?
|
They are flexible but not flexible enough to fit though the hole.. And there is that problem of lining it up properly and attaching it there. But if you built a ship inside a glass bottle before then you would have no problem. LOL
__________________
Pfadt Sway Bars - FE3 Suspension - Barton Shifter - IdealG's Clutch Master Cylinder - Trifecta - Vmax TB - Vararam Intake - MACE 25mm Insulator - Plenum Insulator - Ported/Gasket Matched Intake Manifold - Rx Catchcan - AAC DRL's - 4 Pack Aux Gauges - Steering Controls - AAC Afterburners - DIY Led Sidemarkers - ZL1 Front End
Next mod: Done!