Thread: Wiring question
View Single Post
Old 01-24-2013, 01:40 PM   #4
My Caroline

 
My Caroline's Avatar
 
Drives: Black 2011 Camaro LS
Join Date: Feb 2011
Location: Texas
Posts: 1,694
DO NOT mess with the seats. You will set off an airbag, which is not only dangerous but expensive.

With the driver side door open, pop off the trim piece on the side of the dash, there are three tabs.

Fuses 17 and 18 are KEYED sources (power is only on when the key is in the ACC or ON position). Place an appropriately sized fuse in the back of a fuse tap. Wire the fuse tap to the HOT/power wire on the CB. Place the fuse tap in fuse 17 or 18. Wire the ground to the frame bolt. It is located in the same compartment near the fuse box toward the front of the car.

Hope this helps!
__________________
White Fender Hashes from Big Worm Graphix with Custom White Bowties
GM Factory Remote Start and Factory Key Fob
SS Fascia, Factory RS HIDs, Plasma P13W fog lights
Non-RS to RS and fog light harness by Gen5DIY
LED Interior, Trunk, and Licence Plate lights in white
ZL1 Spoiler with Gen5DIY harness
Factory NPP cat back
Blacked out tail light bezels
Factory 20 inch wheels wrapped in Nitto Motivos
Lowered 1.25inch on Eibach Pro springs
My Caroline is offline   Reply With Quote