Thread: Oil Leakage!
View Single Post
Old 09-27-2010, 04:39 PM   #22
camaro5


 
camaro5's Avatar
 
Drives: X-15 Velocipede
Join Date: Mar 2008
Location: SW Florida
Posts: 4,637
Service Bulletin: #05-06-01-034K: 5.3L, 5.7L, 6.0L, 6.2L, 7.0L-Engine Oil Leak at Rear Cover Assembly Area (Engine Block Porosity RTV Repair Procedure) - (Apr 8, 2010)


Models: 2004-2007 Buick Rainier

2008-2009 Buick LaCrosse Super, Allure Super (Canada Only)

2005-2010 Cadillac CTS-V

2007-2010 Cadillac Escalade, Escalade ESV, Escalade EXT

2003-2009 Chevrolet TrailBlazer

2003-2010 Chevrolet Corvette

2004-2006 Chevrolet SSR

2005-2010 Chevrolet Silverado, Silverado SS

2006-2007 Chevrolet Monte Carlo SS

2006-2009 Chevrolet TrailBlazer SS, Impala SS

2007-2010 Chevrolet Avalanche, Suburban, Tahoe

2009-2010 Chevrolet Colorado Pickup

2010 Chevrolet Camaro

2003-2009 GMC Envoy

2003-2010 GMC Sierra

2004-2005 GMC Envoy XUV

2007-2010 GMC Yukon XL, Yukon Denali, Yukon XL Denali

2009-2010 GMC Canyon

2004-2006 Pontiac GTO

2005-2008 Pontiac Grand Prix GXP

2008-2009 Pontiac G8 GT

2009 Pontiac G8 GXP

2005-2009 Saab 9-7X 5.3i

2008-2009 Saab 9-7X Aero

2003-2010 HUMMER H2

2006-2010 HUMMER H3

with 5.3L, 5.7L, 6.0L, 6.2L, 7.0L VORTEC™ GEN III or GEN IV V8 Engine (All Aluminum Block) (RPOs L33, LC9, LH6, LH8, LH9, LM4, LS4, LS1, LS6, L76, L77, LFA, LZ1, LS2, L92, L94, L99, L9H, LS3, LS9, LSA, LS7)




--------------------------------------------------------------------------------

This bulletin is being revised to add labor time information for the Colorado and Canyon. Please discard Corporate Bulletin Number 05-06-01-034J (Section 06 - Engine/Propulsion System).


--------------------------------------------------------------------------------
Condition
Some customers may comment on an engine oil leak.

Cause
Upon initial diagnosis, it may be determined that the leak is coming from the rear cover gasket. This condition may be caused by engine block porosity on the sealing surface. This issue pertains to aluminum block applications only.

Correction
Follow the steps for Oil Leak Diagnosis in SI to determine the source of the leak. If the leak has been diagnosed as coming from the engine rear cover assembly, refer to Engine Rear Cover Replacement in SI and remove the engine rear cover assembly. Inspect the engine block and engine rear cover for porosity on the mating surfaces.

• If porosity is found on the engine rear cover (see illustration below), replace the engine rear cover assembly, GM P/N 12633579.

• If porosity is found on the engine block, use the following procedure to apply RTV to repair the engine block porosity.

The porosity issue is in the gasket sealing surface at the top of the cover, near the high pressure oil crossover port. Refer to the picture below. The oil leaks by the gasket and runs down the side of the cover, and may appear to be a leak at the t-joint area of the cover. The fix is to replace the cover with GM P/N 12633579. Also, if porosity is found anywhere on the sealing surface of the engine block, use the following procedure to apply RTV to repair the engine block porosity. Refer to the illustration below.

Important: Clean any residual oil from the block and cover before applying the sealant in the next step.

•Wipe a small amount of RTV, P/N 12378521 (in Canada, use P/N 88901148), onto the surface using a plastic scraper to fill the porosity.
•Remove any excess RTV material, especially from inside the high pressure oil passage. Refer to #1 in the above illustration.
•The joint may be closed immediately after applying the RTV. Total joint time after the RTV has been applied must be under 20 minutes.
Important: Refer to Engine Rear Cover Replacement in SI and follow the tightening specifications and sequence.

•Reinstall the engine rear cover using a new gasket and a new crankshaft rear main seal. Refer to Engine Rear Cover Replacement in SI.
Parts Information
Important: For Saab (U.S.) only, use P/N 88861206 - Engine Oil Dye (U.S.) or equivalent.

Part Number
Description
Qty

12574293
Gasket - Crankshaft Rear Oil Seal Housing
1

89060436
Seal, Crankshaft Rear Main
1

12378521

(in Canada, use 88901148)
Sealant
1

88861206

(in Canada, use 88861259)
Dye, Engine Oil
1

12633579
Housing Asm-Rear Cover
1
camaro5 is offline   Reply With Quote