|
Alright guys, I know I'm bumping an old thread but I'll give it a shot anyway cause I need some advice. Just installed speed engineering 1 7/8 headers on my 2013 SS. Also changed the driver motor mount that was shot at the same time. I planned on replacing the passenger side too but long story short, I only received one while I thought I was purchasing a pair. I did the job anyway, hoping that the passenger side mount was still okay. Turns out it's also busted.
Now, I'm wondering, with the headers installed,
-Is there a way to get the job done without having to remove them ?
-Is there a way to get to the top motor mount nuts by removing the wheels and plastic behind it?
-For the driver side, we didn't know if we could jack the engine up. We only let it rest on the jack on a block of wood, removed the 4 bolts holding the stand and then proceeded to remove the motor mount & stand. Could we just jack the engine up 5-6 inches with a block of wood and take the mount out instead of taking out the whole stand?
Thanks
|