Quote:
Originally Posted by verboten
Can someone please post the measurement to position the afterburner in the center of each light?
Is there something thin as aluminum but brighter or more polished to reflect light?
Is a downloadable template that you can print available ? I think I found it - my ipad wouldn't open PDF file.
Thanks
Sent from my iPad using Tapatalk
|
An ingenious poster altered the tabs so that they had slots to adjust the half moons left or right as needed. See that for easier centering.
As far as a downloadable template...the only one I know of is the one I made and posted earlier in this section.
Good luck.