View Single Post
Old 02-02-2014, 04:20 PM   #1
Nutbutt


 
Nutbutt's Avatar
 
Drives: 2011 RJT 2LT/RS Convertible
Join Date: Nov 2009
Location: Western Massachusetts
Posts: 3,382
Install of New PCV hardware

Took my time this morning and installed my Mighty Mouse catch can and RX separator. Made up a bracket for up front mounting and room to reach under to easily drain the can.


Mounted the catch can on the passenger side by the ECU and even modified the engine cover to allow the RX separator and Mighty Mouse catch can to fit underneath. Not sure if I'm keeping this ?
I have a hookup that brings in fresh air through the separator and comes out diagonally to the back left valve cover. Then over to the Mighty Mouse PCV catch can. I have two vacuum sources, one normally to the top of the induction manifold. And a second from before the SC for WOT.
So far it looks pretty clean and no whistling ! Went for a drive and idle was good and an improvement in the idle dive at stops. Would have taken more pics but phone needs to be charged.
__________________
1st IPF Supercharged 2011 2LT/RS RJT Convertible
Nutbutt is offline   Reply With Quote