[ZZcamaro]

This post will include a step by step of our build process...

The first parts I received were from ********....
Steve at ******** was extremely helpful, and the products are amazing. They fit very well, and the finished product turned out better than I had expected.

So here is a little outline of the stereo build:

First, here is a picture of the ******** box being test fit before I bolted it down. You do not need to bolt it down because it fits so tight, but I did because this car will see some aggressive road course driving!!
[IMG]http://i778.photobucket.com/albums/yy64/zeitlermd/********/3-24-2010010.jpg[/IMG]

The most complicated part of the install is bending the mounting brackets just right...I say complicated, but it was very easy to do...the entire install is a virtual no brainer (except for wiring!!!)[IMG]http://i778.photobucket.com/albums/yy64/zeitlermd/********/3-24-2010014.jpg[/IMG]

Here is the bracket installed behind my sound processor
[IMG]http://i778.photobucket.com/albums/yy64/zeitlermd/********/3-24-2010016.jpg[/IMG]

Here is the Amp rack installed and wired up. The amp is an Alpine PDX.5 which is running JL audio components in the front and 6x9 in the rear... The sub is a JL 12W3.
[IMG]http://i778.photobucket.com/albums/yy64/zeitlermd/********/3-24-2010017.jpg[/IMG]

And the final result. I love the clean install and look, and it maintains the pass through of the back seat. The combination o fthe subs and amp sounds amazing!! It is capable of A LOT of bass, but I keep it turned down to where I like it.
[IMG]http://i778.photobucket.com/albums/yy64/zeitlermd/********/3-24-2010020.jpg[/IMG]