Just to clarify...the board is set up for plcc4s which I think are for another cluster that they offer that you can change the color with a push of a button? Not too sure, but all of the leds were actually replaced with plcc2s instead...there was a lot of trial and error with this cluster, but it came out good in the end...
If you want to change the needle color, take the needle off and using a razor blade, scrape off the paint on the back of the needle and the repaint it with an acrylic craft paint, but you have to do a good even job or you will see the "brush strokes" when its lit...
If anyone has any questions feel free to contact me...
|