Also featured on
homepage.
Just got back from the shop. The goal of the day was simply to get *baseline* numbers, so we can justify the real world gains of anything added to the car. Info below:
Dyno type: Mustang
Filter value: 33
Air temp: 78F
Humidity:
83% (ouch)
Car: 2010 Camaro
Engine: 3.6L V6 Direct Injection
Trans: 6L50 6spd automatic
Mod: Bone stock, right down to the plastic still on my carpet.
Octane: 87 (lol)
Best run:
246RWHP | 220lbs/tq
Notes:
* Torque curve is basically flat from 2500 to 5800, dipping by the 6900 mark
* HP curve is a steady arc, flattening out right at redline
* Factory tune is
PIG RICH , holding down in the 11.4 range through the bulk of the run. There is a good bit of power hiding in just a tune.
* We did a run w/ the AC on just for fun - you can see clearly where it was shut off. Lots of power loss at the accy :(
Overall, the numbers are spot on with their factory ratings through an automatic. The exhaust and intake is going to do wonders for the car. The over-rich tune from factory, and the high speed processing capabilities of the Motec ME9 are just begging this motor to be turbo/supercharged.
More to follow throughout the next week or so as parts start to trickle in
Cheers!