This will be a DIY for mounting an ipad2 to your dash with out drilling or any modifications. I found a way to secure the ipad with the help of some other threads on this site. I want to do the DIY right and i will be updating it and adding photos over the next 2 days. I will start with the finished look of the mount.
This Mount uses the following materials
- 2 Large suction cups supporting 7 pounds each
- 3m Velcro
- gorilla super glue
- razor
- ipad2 shell case that supports smart cover
- iphone vent mount
I have been testing this mount for the last 2 days before i decided to post this DIY, The ipad hasn't moved and seems very sturdy over bumps and sharp turns and heat in the vehicle. Just wait for the full write up.
Update-
Start by cutting the suction cups hook off with the razor to make a flat surface
apply gorilla glue to the suction cup and then apply one side of the 3m velcro let dry for up to 4 hours to get a secure bond
Apply other side of Velcro to the ipad shell case
take the iPhone vent holder apart leaving just the vent clips and the base attached
take the 3m Velcro and apply it to the flat side of the vent holder
put the vent holder and suction cups in place like shown in the photo.
mark the shell case to match where the Velcro should go
apply all Velcro to case and stick together to see if the mount holds.
add ipad and enjoy