View Single Post
Old 07-27-2012, 05:55 PM   #11
PfadtRacing
 
PfadtRacing's Avatar
 
Drives: 2010 Camaro, 2006 Z06
Join Date: Feb 2009
Location: SLC, UT
Posts: 3,370
Try this:

Bolt the Pfadt bar back up to the car with the Pfadt brackets but do not install the endlinks yet. Be sure to apply lube to the sway bar to bushing interface and bolt the brackets securely to the car. Try to articulate the bar by hand by grabbing one bar end and trying to rotate it. If it takes a significant effort to manipulate the bar place a washer between the bracket and the chassis and try it again, this should make it easier to rotate the bar within the bushing. Properly torque the rear bar brackets back into place as well as the endlinks. Take it for a test drive.

If it's still making noises let us know. There shouldn't be anything inherently noisy about the bar to bushing interface it's self, so long as it's properly lubricated with the supplied grease.
PfadtRacing is offline   Reply With Quote