Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - DIY

CASTIG 2010SS · 10-19-2009, 08:05 AM

What did you use the stereo wire for? I tried to look in the photos but the best I can make out is maybe used it to pull wire from driver to passenger side?

I think I see what you did, you put a plug on each end to extend the EL wire. I just realized how short you connector wire was coming off each piece. Why not make it a continuous wire when soldering? Can't you solder the speaker or some other wire to the EL and then put just one connector at the end?

10-19-2009, 08:05 AM	#21
CASTIG 2010SS Drives: 2010 CGM Camaro SS\RS Join Date: Apr 2009 Location: PA Posts: 56	What did you use the stereo wire for? I tried to look in the photos but the best I can make out is maybe used it to pull wire from driver to passenger side? I think I see what you did, you put a plug on each end to extend the EL wire. I just realized how short you connector wire was coming off each piece. Why not make it a continuous wire when soldering? Can't you solder the speaker or some other wire to the EL and then put just one connector at the end? __________________ 2SS CGM, IO Interior BAD 2SS West Chester, PA Last edited by CASTIG 2010SS; 10-19-2009 at 08:16 AM.