|1st & 2nd Generation Camaros 1967-1969 Camaros / 1970-1981 Camaro|
|04-04-2010, 02:05 PM||#1|
Drives: 2010 Camaro 2SS/RS LS3 M6 #603
Join Date: Jun 2009
just picked up 67 camaro need some engine help
just baught a 67 camaro. Engine block is a 1983 350 block. dont know if its a 2bolt or 4 bolt. in 83 there were both. Heads are 327 double humps/camel humps, Straight Plug version.
its got a Crane/Cam dynamics street plus Cam
valve adjust int .022, valve adjust exh .024
valve lift int .493, exh .512
tappet lift of .050
ground lobe 112 degrees
Edelbrock Torker intake
Holley 670 street avenger carb
I went to tune it up yesturday and removed the plugs.
According to Autolite the plugs i am supposed to use are PN# 85
14mm thread, 9.5mm reach.
Plugs I removed were PN#36 and dicontinued. replaced with 46
18mm thread, 11.6mm reach. Also the 46 series plugs were for Ford Applications
Any gear heads out there have any idea why these plugs would of been used?
also want know know if there is a valid reason why the PCV vacuum shouldnt be connected from the head to the carburators PCV vacuum port?
|04-04-2010, 02:30 PM||#2|
'69 Owned Since '79
Drives: '69 Z/28 LeMans Blue w/White
Join Date: Oct 2008
Location: LR AR
You need plugs to match the cylinder heads. I don't know for certain which head casting you are running but if they are truly double hump early style heads (291's for example) the 85's should be good. A head casting number would help nail it down.
|04-04-2010, 04:03 PM||#5|
Drives: SST Camaro 2010
Join Date: Oct 2008
Location: East Coast of Florida
Sounds like whoever built the motor did a reasonable job of matching the components. Match the plugs to the heads and compression ratio. Normally aspirated SBCs are very forgiving with plugs.
As far as the PCV, it has two purposes: across the board it will lower the positive pressure of ring blowby in the crankcase and under higher vacuum conditions it helps the rings seal better.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Does the v6 have enough power?||cstproductions||Camaro V6 LLT Engine, Exhaust, and Bolt-Ons||305||08-29-2012 10:27 PM|
|Camaro Product Manager - interview||Moose||5th Gen Camaro SS LS LT General Discussions||11||04-04-2012 07:10 PM|
|The BEST Break for a new car. "very long"||Darin Morgan||General Automotive + Other Cars Discussion||346||02-04-2010 07:49 PM|
|Official Camaro Convertible CONCEPT Press Release||Tran||Camaro Convertible Forum||12||11-18-2009 08:05 PM|
|4 SEMA CAMAROS finally unveiled by GM! (hi-res images & details)||FenwickHockey65||Camaro Photos | Spyshots | Video | Media Gallery||237||11-03-2008 11:39 PM|