![]() |
|
Homepage | Garage | Wiki | Register | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools |
![]() |
#1 |
![]() Drives: '13 LFXv6 Join Date: Feb 2013
Location: Texas
Posts: 17
|
problems with eibach lowering springs
Just installed a set of eibach lowering springs on my 2013 v6 camaro. Install went really well but the front shocks arent sitting right. Under the hood on the single screw the bolt/washer sits higher than it did causing the top bolt and washer to be approximately 1/4 inch higher. In other words the top bolt and washer do not hold the shock in place and if i drive it it seems like it would bounce around. They were tourqued down to spec and was told i do not need to trim the bushings or anything for this install. Anyone have any ideas? I will try to get pictures later this afternoon once I get back home
|
![]() |
![]() |
![]() |
#2 |
![]() Drives: '13 LFXv6 Join Date: Feb 2013
Location: Texas
Posts: 17
|
It seemed like it was tight on it when i first took it off.... I figured like that the spring would bounce around going over a good bump or two?
|
![]() |
![]() |
|
|
![]() |
Thread Tools | |
|
|