Roto-Fab ZL1 CAI

[hawk02]

Originally Posted by Camarozl1guy

I am pricing the Intake for my ZL1, Can some tell me what they are calling the BIG GULP? or show me a pic.

Thanks

They're calling it Big Gulp Air Intake/adjustable Brake Duct on their web site (www.roto-fab.com)

[rjs2010SS]

Originally Posted by HDRDTD

There is a post on the bottom of the shield that fits through a rubber grommet on the frame.

Make SURE that the rubber grommet is fully seated in the frame and that the post is fully seated as well.

It's easy to unseat the grommet when you're pushing on the shield when installing it.

DAMHIKT.

I actually have the same exact problem. When I get my car back from the detailers from some compounding/polishing action, this and installing the ported VMAX is first on the list to do.

[mikystyle]

Originally Posted by rjs2010SS

I actually have the same exact problem. When I get my car back from the detailers from some compounding/polishing action, this and installing the ported VMAX is first on the list to do.

I checked my post and it's fully seated. It's the actual heat shield. The lower drivers side corner hits the top of the inner fender well and has actually taken a bit of paint and that's where it's holding the hood up. In going to try some adjusting and if not grind of a little and repaint the shield. Ps this shouldn't be a step in the installation, I'm just glad I'm not the only one.