07-18-2013, 05:58 PM | #1 |
Drives: 2012 AGM Camaro RS/SS Join Date: Dec 2011
Location: NY
Posts: 110
|
Stainless Power Headers almost here!
My Long tubes with high flow cats from Phastek should be here tomorrow, I have the day off so I'll try to get around to installing them. Can you install the headers and high flow cats to mate up with the factory H-pipe without dropping the H-pipe/ full exhaust system? I'll make sure to post up before and after sound clips of my exhaust. Current exhaust SLP LMII Axle back (Not for much longer) Can't wait!!
__________________
Matte black Forgestar F14's 20x9/20x11,Matte Black ZL1 Splitter/Heritage grill/taillight bezels,mail slot vinyl and SS Badge, Blacked out Lights/markers, Tinted, CAI Cold air intake, Stainless Power Longtubes, HFC's, SLP LMII axle back, JRE Tune, BMR 1'' Lowering Springs/Rear Sub Frame Connectors/Tunnel Brace,Trailing arms.Granatelli front sub frame connector, GM Strut Tower Brace.
|
07-18-2013, 09:25 PM | #2 |
Eh, that'll happen
Drives: 2010 2SS Join Date: Apr 2012
Location: Mesa, Arizona
Posts: 1,841
|
Yes, its just a game of Tetris when installing. Once the headers are on, youll then put the cats on as far up on the headers as you can push them. Youll have to push the H pipe off towards the middle of the car as you are installing the cats. Once the cats are on as far as the header will allow, slide the H pipe back into place and then pull the cats back down to make the connection. Obviously make sure all clamps are in place so you dont have to pull everything back apart again! Its easier if you have a friend connect the other side at the same time so youre not fighting the connection youve already made...if that makes sense?
__________________
2010 Camaro SS LS3 - No Modz
|
|
|
|
|